M3D
32 Bit Engine Management system
The Emerald M3D 32 Bit
engine management system handles full 3D mapping of both ignition and
injection on normally aspirated, turbo and nitrous
injected from 4 to 12 cyl. engines. Its easy programmability and
flexibility in adapting to existing engine installations and sensors make it a
particularly good choice for racing cars, 4X4s and for conversion of existing manufacturers
systems to mapped ignition and injection.
The
software provides 32 speed sites(up to 15500 RPM) and 16 load
sites with tailorable load site grouping allowing super sensitive mapping
around part throttle to improve drivability. The injection software provides
the same number of load sites and speed sites, and also allows for cranking
enrichment, acceleration fueling adjustment, cold start correction, water and
air temperature correction to both fueling and ignition settings and Lambda
sensor feedback. Map trimming can be done both 'on the fly' in Real
Time dialing in timing and fueling settings while the engine is running,
or on a download basis.
M3D units
incorporate an 8 channel Data Logger, a shift light, user tailorable soft
and hard cut rev-limiters, tacho drive and tacho tell-tale.
Specification
Dimensions: height 45mm width 109mm
(140mm with mounting lugs) x l 90mm
Weight: 371g (ecu only)
Max current: 250mA
Input trigger:
Distributor
-Magnetic reluctance pickup
-Hall effect
-Optical
Distributorless
-1 phase sensor and 1 crank
sensor with 2 pickups (4 cyl)
-1 sensor, multi-tooth
pickup (GM 60-2
cranktrigger, Ford 36-1 cranktrigger or custom)
Fuel pump relay control - 1 amp max.
Shift-light - 1 amp
max. (12w bulb)
Tacho drive - 12v
pulsed output